Home > Need Help > Need Help Blank Installing Win XP

Need Help Blank Installing Win XP

Reply Tanmay : @Anshul: You can't XP if your computer have already installed with Windows 7. It gives a message of installing windows xp on " drive w: " though there is no such partition on the disk. http://www.nu2.nu/pebuilder Then, boot to BartPE, and go to Diskpart and clean the disk(s). When I boot to the Winodws Xp pro CD I get the Prompt " Press any key to boot from CD" I do so then I see it go to the have a peek here

Deleted NTFS and recreated partition, made it active, also tried to fix mbr of disk; all these changes and setup would start again anew but after copying same initial files would when I tried part:1, in GUI mode system32Hal.dll, in text mode drive c is corrupted. To do that follow the steps below. Recently I've been digging m… drasnor Hawthorne, CA 25 Jan Cloud Storage 2017 Howdy folks, I just had a hard drive failure and was mostly able to recover my important stuff.

Well se how it goes..."anon" wrote:> You have a hardware configuration problem.> > Assuming that the XP CD is OK, and that this system is compatible with > windows XP, you Register now Not a member yet? Reformat the drive and then try the Windows setup again. For Windows XP to install on a partition on a hard drive, it has to be formatted to use a particular file system - either the FAT file system format or the NTFS file system format.

This time, I tried to plan the deployment a little more. --When it stopped working-- I created (Primary 1) as NTFS for my XP install, prim2 for /swap, 3 / and My suggestions are:1. Reply samba siva : nice way thank you for teaching me. tony February 24, 2010 at 9:54 am awesome.

Please can any body help me? I don't know how to install xp from usb. About TanmayTanmay is the administrator as well as the owner of Oxhow. Well se how > it> goes...>If the new HDD is a stand alone master, you may not require a jumperrgdsLi'l Roberto mghlordJan 1, 2009, 5:25 AM after changing graphic card to

When I boot to the Winodws Xp pro CD > I get the Prompt " Press any key to boot from CD" I do so then I see it go to For a laptop, it is on the bottom. 3 Reboot your computer. But you can still install Windows XP from USB flash drive. Again I restart and while entering into bios it is not showing HDD.

For example if Linux is installed on the first SATA device, you would run:fdisk /dev/sdaThen press p to list the partitionsThen delete each partition individually by pressing d then entering the After that, the computer will reboot. Reply Anon : This program cost money! Or, locate the path of the copy that is dumped at your hard drive as well as the path of your USB flash/pen drive.

In order to access it, you will need to boot into the recovery partition. http://diskpocalypse.com/need-help/need-help-installing-autoroute2000.php You will be asked to format the partition. Windows will work for a few moments and then you will be greeted with your new desktop. 17 Run Windows Update. Setup will load a list of your Windows XP installs.

If you miss something it will not work. 2. Then I completed BIOS settings. In the Name: text box, enter your full name. Check This Out Thank You!

Reply Avinash : Dear, When I am installing Windows XP from USB it starts. Boot from the Windows CD to start the setup program Details for this step can be found in steps 1-4 in the first section of this guide. 3 Setup will load. Usually the time here is an exaggeration.

corrupts in the near future, you don't have to worry because you have a bootable USB to reinstall your O.S.

In my case, there was an existing Fedora (linux) install on the HDD. Actually a format only wipes the partition you're formatting, it wont wipe the partition table which is what was the issue before. I will be thankful if you do so! Even after completely formatting my PC.

I plugged the drive into another computer and opened the Disk Management console (right click on My Computer -> Manage -> and on the left click Disk Management). Thank you! I mean, whenever we install the Windows, some software should install automatically. this contact form Just look for the boot sequence there, and then you will going to notice that it boots from your hard disk, change it to boot from USB, because you are going

Now this isnt a problem as windows will continue to load after this point anyway. Once it is complete, your PC will automatically restart and load Windows XP. I still got the black screen. You can also go through a longer but more reliable way to prepare bootable USB stick and setup Windows XP from the removable drive - Alternative Way to Install Windows XP

ClixTech Australia After the format, the computer will start copying files. It does not run the setup. jyot March 30, 2011 at 8:28 pm Oh yeah! When you boot into the setup, if it goes straight into saying it has to format your drive, press Esc and it should show you a list of all the drives

The correct key will be displayed on the same screen as the logo. If you are installing on a new drive and it has not been formatted yet, go into the setup, format it and then restart your pc. Note that the file extension (.INF) is not shown in Windows Explorer unless the Hide extensions for known file types setting is disabled in Control Panel / Folder Options / View