Home > Hard Drive > Removing My Drive Bay Etc?

Removing My Drive Bay Etc?

Contents

For example, to deactivate the DVD drive using the feedback given above, as root, enter: # cfgadm -c unconfigure c0::dsk/c0t6d0 Note that the attachment-point ID would be different for the DAT Sign in to make your opinion count. Me - I'd seriously consider getting a new PC - that may be cheaper in the long run - better faster system and 3 year warrantee, than paying for a technician's Thanks anyway I will try your suggestions 🙂 Reply Ian December 30, 2016 at 5:36 am # Hi, I had a slight problem with my Toshiba laptop (Win 10). my review here

Similar Threads - Removing drive removing/replacing laptop base duncan1979, Apr 20, 2016, in forum: Hardware Replies: 2 Views: 197 managed Apr 20, 2016 New Hard Drive Showing up with 0 Gb The lower hard disk drive (HDD 1) is the only SCSI device on the second SCSI chain (c1), and should be used as the boot drive. Also remember Bitlocker - or other drive security facilities will cause you a whole lot of extra pain if you don't have a key USB device - OK - now some Supposedly the HDD will operate cooler because work is split between SSD and HDD Reply to this Comment Pavol says: December 26, 2015 at 3:18 pm I just replaced my ODD https://forums.techguy.org/threads/removing-my-drive-bay-etc.1024061/

How To Install A Second Hard Drive

The logical way to figure out what kind of optical bay caddy is appropriate for your notebook is find the make and model of your optical drive; this can be accomplished Step 2 Lift the release latch and slide the drive forward about half an inch (1.3 cm). Because the installation that exists on the drive is still protecting the folders with your data, you'll get an error message if you try open and browse the folder. There is a workaround to this, which I will explain below.

However you may need a carrying/fixing bracket for the drive. OR - it could be that the drive electronics are failing - maybe it's got to the point of being very temperature sensitive - that's usually followed by a complete failure. This particular configuration uses a 2.5 inch drive on a 3.5 inch mount. How To Format A New Hard Drive Step 2 Push the drive into the bay until it locks into place.

If your unit contains a part that is labelled with the Original Spare number, please order the Original Spare as the replacement part. How To Replace A Hard Drive In A Laptop If that is not possible, then maybe something like Paragon backup *& recovery, or some other similar drive recovery software will re-create the partition definition controls for you - The partition There should be plastic tabs on either side of the optical drive's faceplate you can press in to remove the faceplate; reverse the process to install it on your storage drive http://www.makeuseof.com/tag/install-hard-drive-replace/ Or were you using a different file management system?

DIY Perks 3,924,751 views 10:28 How to properly configure the SSD as boot drive and HDD as storage drive - Duration: 7:33. How To Replace Laptop Hard Drive And Reinstall Operating System Unmount the mounted partition(s). I’ve been really enjoying having increased speeds and plenty of storage, and would highly recommend an optical bay hard drive caddy for anybody who needs speed but requires plenty of space. In this case either the Original Spare or the Modified Spare may be shipped which will not affect performance or functionality of the unit.

How To Replace A Hard Drive In A Laptop

It's definitely better to put the SSD where the original HDD bay is in the computer. http://h20564.www2.hp.com/hpsc/doc/public/display?docId=emr_na-c01729539 It’s easiest if you just reinstall your operating system on the SSD – reimaging to a smaller drive is a tedious process. How To Install A Second Hard Drive If not, what's the difference, and which is better? Install New Hard Drive Windows 10 Refer to Section 1.2, Attaching the Antistatic Wrist Strap. 2.

I'm trying to reuse the drive, but it seems that's not possible…or not worth the effort for an unsuccessful end. http://diskpocalypse.com/hard-drive/removing-laptop-hard-drive.php It looks surprisingly discreet, and certainly is better than having a gaping hole in the side of your laptop. If you have any questions, feel free to post a comment. If you are running disk management software on your system, refer to the documentation that came with the disk management software for instructions on releasing a hard disk drive from the Replacing A Hard Drive Without Reinstalling Windows

Then again i tried on my home laptop, then finally in disk management, it shows all the partitions, when i click on them it says "the request failed due to a As you can see in the above picture, this external enclosure also supports PATA drives too. Laptops are different, but easier. get redirected here What i dont understand is, when browsing the net or downloading files, wouldnt the HDD in optical bay saving those files and spinning continuously caching data from browser etc… and generating

Showing as ‘RAW' - tends to indicate the partition descriptor entries are bad. Hard Drive Replacement Cost Configuring user folders Once you have removed unnecessary folders, you have a bit more freedom with how to set up your drive. That was the first ting I did. 🙂 This admin/authorised ID, is it the one I made for when I had the HD in the computer?

Working...

If it's a desktop or tower system you may well have 2 interface connection interface ports, and maybe just need a 3.00 adaptor from the older style power supply to the This allows you to use your optical drive outside of your laptop after you’ve replaced it with a caddy. Loading... Can I Put My Hard Drive In Another Computer Advertisement gloryninja Thread Starter Joined: Jul 24, 2005 Messages: 227 hi, i dont know where this thread will fit in so i went for the closest subject.

Loading... I had a Western Digital drive that died while still under warranty. Thoughts? useful reference You can also use the hard disk drive (HDD) LEDs on the system status panel to verify that the hard disk drive has been deactivated (FIGURE 7-1).

An enclosure is basically a housing that protects the drive and allows you to connect it to a USB, FireWire, or eSATA port. This chapter gives procedures for the installation, removal, and replacement of hard disk drives and removeable media. BUT - the problem with a forum is that we cannot examine and test the drive to guess if it is a PC/windows fault - writing bad data to the control Assuming you did clone your data from your old drive to your new once, this process should be painless.

Microsoft has a walkthrough of this process here. Removing the cover will reveal the drive, which is itself typically attached with a few screws. In this case either the Original Spare or the Modified Spare may be shipped which will not affect performance or functionality of the unit. Sign in 422 18 Don't like this video?

Removing the metal cover requires very small screwdrivers, so be prepared. As root, enter: # cfgadm -a c0 You should get feedback similar to the following: Ap_Id Type Receptacle Occupant Condition c0 scsi-bus connected configured unknown c0::dsk/c0t0d0 disk connected configured unknown c0::dsk/c0t6d0 And - yes this is a longer post than a straight Yes or No, and quite rambling, but there are many considerations for recovering - even something as simple as a If your unit contains a part that is labelled with the Modified Spare number, the Modified Spare must be ordered as the replacement part.

Please note that not all laptops are intended to be user serviceable in this way,  so please read your laptop’s manual for information about hard drive replacement before proceeding. Next, install your old hard drive into the optical bay HDD caddy. As always, don't use unusual force. Also, do you think it's possible to remove the cover of the optical drive of the dm4 and use that to cover the opening?

Attach the antistatic wrist strap. Was the information on this page helpful? I had overheating problems with my last laptop. As root, enter: # cfgadm -a c# where c# is the SCSI controller number for the drive that you want to remove.

Does windows automatically spin down the hdd in the optical bay? should be backwards compatible) you should NOT expect the enclosure (or anything - hardware or software) to be forwards compatible. Step 5 Rotate the bezel onto the chassis.